This document describes the basic installation information for the 2GIG
Technologies HD100 Camera (2GIG‐CAM‐HD100). To install the HD100
Camera, you will need a PC with internet access.
• Camera base
• Wire retention clip
• Power adapter
• 4 non‐slip adhesive feet
|PIR Max||5m coverage|
|IR LED 5m||illumination|
|HD Video||Up to 720p 15fps|
WiFi to the On-Site Router (WPS)1 If the on‐site router supports WPS, press the WPS button until the router goes into WPS mode (this will differ slightly from router to router). This action causes the router to listen for a new WPS device.
2 Press the WPS button (A) on the HD100 Camera. This action causes
the camera to announce itself to the router as a WPS device. While the camera is in WPS mode, the camera displays a blinking yellow LED.
3 Do not press any buttons on the HD100 Camera until the camera LED displays green, indicating that the camera has successfully connected to the network.
4 From the Alarm.com website add and configure the camera.
WiFi to the On-Site Router1 Connect the camera directly to the router using an Ethernet cable.
2 From the Alarm.com website add and configure the camera to connect using WiFi.
3 Disconnect the Ethernet cable from the camera. A WiFi connection will be established.
Ethernet to the Router1 Connect the camera directly to the router using an Ethernet cable.
2 From the Alarm.com website add and configure the camera